DataSheet.in

EL7900 डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - Ambient Light Photo Detect IC - Intersil Corporation

भाग संख्या EL7900
समारोह Ambient Light Photo Detect IC
मैन्युफैक्चरर्स Intersil Corporation 
लोगो Intersil Corporation लोगो 
पूर्व दर्शन
1 Page
		
<?=EL7900?> डेटा पत्रक पीडीएफ

EL7900 pdf
EL7900
Absolute Maximum Ratings (TA = +25°C)
Supply Voltage between VSD and GND . . . . . . . . . . . . . . . . . . . .6V
Maximum Continuous Output Current . . . . . . . . . . . . . . . . . . . . 6mA
Operating Temperature . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
ESD Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2kV
Maximum Die Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . +125°C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-45°C to +100°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA
Electrical Specifications VCC = 3V, TA = +25°C, fluorescent light, unless otherwise specified.
PARAMETER
DESCRIPTION
CONDITION
ICC1
Supply Current
RL = 1kΩ, EV = 100lux
EV = 0lux
ICC2
Supply Current When Disabled
EN = VHI
IL1 Light Current
EV = 100lux
IL2 Light Current
EV = 10lux
ILEAK
Dark Current
EV = 0lux
VO(MAX)
Maximum Output Compliance Voltage at 95% of nominal output current, EV = 100lux
tR Rise Time (Note 1)
RL = 5kΩ, EV = 300lux
RL = 1kΩ, EV = 1000lux
tF Fall Time (Note 1)
RL = 5kΩ, EV = 300lux
RL = 1kΩ, EV = 1000lux
tD
Delay Time for Rising Edge (Note 1)
RL = 5kΩ, EV = 300lux
RL = 1kΩ, EV = 1000lux
tS
Delay Time for Falling Edge (Note 1)
RL = 5kΩ, EV = 300lux
RL = 1kΩ, EV = 1000lux
VLO Maximum Voltage at EN Pin to Enable
VHI Minimum Voltage at EN Pin to Disable
ILO Input Current at EN Pin
VEN = 0V
IHI Input Current at EN Pin
VEN = 3V
tEN Enable Time
EV = 200lux
tDIS Disable Time
EV = 200lux
NOTE:
1. Switching time measurement is based on Figures 1 and 2.
MIN
39
1.8
TYP MAX UNIT
62 µA
1 µA
1.2 µA
60.5 82
µA
6.2 µA
10 pA
2.7 V
105 125
µs
64 µs
170 225
µs
77 µs
165 200
µs
112 µs
65 85 µs
33 µs
0.6 V
V
0.01 µA
2 µA
140 µs
2 µs
PULSE
DRIVE
VCC
EL7900
VOUT
RL
FIGURE 1. RISE/FALL TIME MEASUREMENT
PULSE DRIVE
CH1
tD
1V
1ms
tS
VS = 3V
TA = +27°C
0.5V
80%
CH2
VOUT
tR
20%
tF
FIGURE 2. RISE/FALL TIME MEASUREMENT WAVEFORMS
2 FN7377.5
February 6, 2007

विन्यास 7 पेज
डाउनलोड[ EL7900 Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
EL7900Ambient Light Photo Detect ICIntersil Corporation
Intersil Corporation


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English