DataSheet.in

uRAM2C21 डेटा पत्रक PDF( Datasheet डाउनलोड )


डेटा पत्रक - Output Ripple Attenuation Module - Vicor Corporation

भाग संख्या uRAM2C21
समारोह Output Ripple Attenuation Module
मैन्युफैक्चरर्स Vicor Corporation 
लोगो Vicor Corporation लोगो 
पूर्व दर्शन
1 Page
		
<?=uRAM2C21?> डेटा पत्रक पीडीएफ

uRAM2C21 pdf
Electrical Characteristics
PRELIMINARY
Electrical characteristics apply over the full operating range of input voltage, output power and baseplate temperature, unless
otherwise specified. All temperatures refer to the operating temperature at the center of the baseplate.
µRAM MODULE SPECIFICATIONS (-20°C to +100°C baseplate temperature)
Parameter
Operating current range
µRAM2xxx
µRAM3xxx
Min Typ Max
0.02 20
0.02 30
Unit
A
A
Operating input voltage
Transient output response
Load current step <1A/µsec
Transient output response
Load current step <1A/µsec
(CTRAN = 820µF)
VHR headroom voltage range(1)
@ 1A load
Output ripple
Input Vp-p = 100mV
3.0
325
30 Vdc
50 mVp-p
50 mVp-p
425 mV
10 mVp-p
5 mVrms
Output ripple
Input Vp-p = 500mV
SC output voltage(2)
OR’ing threshold
µRAM bias current
Power Dissipation
µRAM2xxx VHR = 380mV@1A
µRAM3xxx VHR = 380mV@1A
10 mVp-p
5 mVrms
1.23 Vdc
10 mV
60 mA
7.5 W
11.5 W
Notes
No internal current limiting. Converter input must be
properly fused such that the µRAM output current
does not exceed the maximum operating current
rating by more than 30% under a steady state condition.
Continuous
Step load change;
see Figures 9, 12, & 15, pp. 6-7
Optional capacitance CTRAN can be used
to increase transient current capability; See Figures
1 & 2 on p. 3 and Figures 10, 13, & 16 on pp. 6-7
See Figures 5, 6 & 7
See Table 1 for headroom setting resistor values
Ripple frequency 60Hz to 100kHz; optional capacitor
CHR = 100µF required to increase low frequency
attenuation as shown in Figures 3a and 3b
see Figures 8, 11, & 14, pp. 6-7
Ripple frequency 100kHz to 2MHz;
see Figures 8, 11, & 14, pp. 6-7
See Table 1 RSC value
Vin – Vout
Vin = 28V; Iout = 20A
Vin = 28V; Iout = 30A
(1) Headroom is the voltage difference between the +Input and +Output pins.
RHR = (µRAM +Out/VHR) x 2.3k (see Table 1 for example values)
(2) SC resistor is required to trim the converter output up to accommodate the headroom of the µRAM module when remote sense
is not used. This feature can only be used when the trim reference of the converter is in the 1.21 to 1.25 Volt range.
(see Table 1 with calculated RSC resistor values)
RSC = ((µRAM +Out)/1.23V x 1k) – 2k
µRAM Out
3.0V
5.0V
12.0V
15.0V
24.0V
28.0V
VHR @ 1A
375mV
375mV
375mV
375mV
375mV
375mV
RHR Value (ohms)
18.4k
30.6k
73.6k
92.0k
147.2k
171.7k
RSC Value (ohms)
0.439k
2.07k
7.76k
10.20k
17.50k
20.76k
Table 1—RHR and RSC are computed values for a 375mV case. To compute different headroom voltages, or for standard resistor
values and tolerances, use Notes 1 and 2.
Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715
MicroRAM Data Sheet
Set your site on VICOR at www.vicorpower.com
Rev. 1.1
Page 2 of 8

विन्यास 8 पेज
डाउनलोड[ uRAM2C21 Datasheet.PDF ]


शेयर लिंक


अनुशंसा डेटापत्रक

भाग संख्याविवरणविनिर्माण
uRAM2C21Output Ripple Attenuation ModuleVicor Corporation
Vicor Corporation
uRAM2C22Output Ripple Attenuation ModuleVicor Corporation
Vicor Corporation


भाग संख्याविवरणविनिर्माण
30L120CTSchottky RectifierPFC Device
PFC Device
AT28C010-12DKSpace 1-MBit (128K x 8) Paged Parallel EEPROMATMEL
ATMEL
B20NM50FDN-CHANNEL POWER MOSFETSTMicroelectronics
STMicroelectronics
D8442SD844SavantIC
SavantIC
FAE391-A20AM/FM Automotive Electronic TunerMitsumi
Mitsumi


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z



www.DataSheet.in    |   2017   |  संपर्क   |   खोज     |   English